Card Holder #2

                             Card holder project.  👀

               This project was request by a friend since 17th July 2017 under title of post "Trying male small gift".👀

But was put on hold as there were other urgent job on hand.

There is three different design for card holder.

Now revisit this project again for card holder (with ample space for RFID case holder not shown here).
This is a sample card holder provide by friend, hence taken some measurement.

Card Holder front view

Rear view in open position

Overall measurement view

Note:- Work in progress, sorry for the inconvenience.

Update 16th Nov 2018.

Still not ready yet as searching material of suitable thickness... please wait and thank you for patience.

Update 23rd Nov 2018.

Was busy with work life, as during week end have opportunity to continue project.

Draw drain line for punch hole

Temporary remove layer to add button

Add a strap with button

Strap hidden

Cut slot for strap

Rear view of project

Stitch the strap to outer layer

Pre assemble by punch hole
for outer and inner layer

Cut slotted line for strap to
sit in

Mark line for punch hole

 Inside view of finish product

Out side view.














Rear outside view

Update 24th Nov 2018.

Another card holder of different material and bigger flap.. The bigger size is to conceal the VT2 button

Bigger design flap

Punch hole along expose edge

Layout various part of project

Punch hole for cutting slot line

Trim part of thicker flap

 reduce thickness by remove part of the leather

Sand paper surface before gule

Cover the button metal part

               = * = * = * = * =

Slightly different design with different leather material for this project. Try use a softer material on inside.

Layout material for proejct

 Mark position for button

Sew one of the edge (flap)

 Align and position coin for cutting round edge

Prepare for punch hole for button

one way to cut curve line

Front view of project

Rear view of project

Inside view of project

Three design for card holder.

Update 28th Nov 2018

Provide additional information on RFID casing and card holder as how it is interface and attached.

It give clear view how they are interface and works together.

 Side view to show how the RFID casing attached to card holder.

Another angle to view card holder with one side of edge attached

a RFID casing which make possible to store on card holder design.

RFID Automatic Pop Up Card Holder Aluminum Alloy dimension is 9.6 cm x 6.3 cm x 1 cm.

Happy card holder project coming this way..💁

                                               = = = = = =  End of Document = = = = = =👨