Another small project for leather tool, burnishing roller.
Prepare to cut wooden block to required size.
Use a ply wood with a Aluminum L bracket to guide edge of circular saw.
Note:- the type of wooden material is also a factor to consider, in this case use a softer wood material.
When time permit, will try other wood material and compare it effectiveness.
Marking for cutting and use scrap peg to prevent cut gap compression by bench jaw when it tighten the jaw grip.
First rough cut the outline of the tool.
Drill hole for center point on tool
Trim off the unwanted part
final groove cut for burnishing tool
use tool to shape groove.
try out on project..looks good so far. Need
Update 19th Nov 2018.
Base on feedback from other leathercraft expert, material of wood play an important part for burnishing tool.
Hence need more time to experiment and evaluate how effective for each type of wood material.
End of document..
Use a ply wood with a Aluminum L bracket to guide edge of circular saw.
Note:- the type of wooden material is also a factor to consider, in this case use a softer wood material.
When time permit, will try other wood material and compare it effectiveness.
Marking for cutting and use scrap peg to prevent cut gap compression by bench jaw when it tighten the jaw grip.
Trim off the unwanted part 
use tool to shape groove.
try out on project..looks good so far. Need
more time to test out how effective is this wood material.
Update 19th Nov 2018.
Base on feedback from other leathercraft expert, material of wood play an important part for burnishing tool.
Hence need more time to experiment and evaluate how effective for each type of wood material.
End of document..
No comments:
Post a Comment