Hard Disk carrying pouch
Another version, side way pocket HDD case.
Trim corner to create "Pocket", try use a square punch hole for the corner edge.
Use Slim HDD to verify size and measurement for leather project
Glue the outer layer with inner layer to act as pocket.
Use a square punch for corner.
use bamboo chop stick as "vice" to help in grip soft leather edge and make it easier to do burnishing process.
After punch hole for both layer for the side remove. Next punch hole for bottom edge.
This is one method allow to create a "pocket"
Gule the bottom layer in preparation for punching hole.
Punch hole for the bottom edge
Check the align for punch hole.
cut a slot hole to allow flap to be insert
for stitching.
Use Cut line for the top flap cover
pre punch hole for flap edge and next apply glue on flap and outer layer
Punch hole for top flap is to add reinforcement the narrow strip
Another version, side way pocket HDD case.
This is one method allow to create a "pocket"
cut a slot hole to allow flap to be insertfor stitching.
a oblong punch for both end
pre punch hole for flap edge and next apply glue on flap and outer layer
 |
| Use double sided tape is for temporary attached to align for button hole position. |
Add a layer to conceal button for flap.
End of document
No comments:
Post a Comment