HDD carrying pouch #5 Part 2

              View of finish product for HDD carrying pouch.

For more details on how to fabricate this please refer to post title HDD carrying pouch #5 ,dated 12 Nov 2018.

View on Levono F310S standard Hard Disk Drive casing.

 Front view of project.. when insert a Levono F310S HDD casing is a bit tight to fit in.
This HDD casing have another pouch for keeping the USB3 interface cable.

Rear view of project

Inside view of Levono F310S hard disk drive casing

The HDD and interface cable slot can be interchangeable as can be seen here. This is dependent on the user desire and needs, which slot they prefer to use.

HDD sit on the front slot

HDD sit on the rear slot

* Note:- the flap design was a bit shorter hence it take some difficulty to snap close for the button.

Update on 2nd Dec 2018

Final stitches done for the flap and add a few more stitch between the flap and outer layer.

Saddle stitching step#1

Saddle stitching step#2

Saddle stitching step#3

Saddle stitching step#4

 This how the stitch looks like from the inside.

View on stitch from the outside.

Finish product after all the hard work and to punch hole, cut edges, sand paper, guling, trim edge, burnish the edge, attached button..and etc.

Update 3rd Dec 2018.

A friend receive this gift for HDD carrying casing.

proud owner for HDD carrying case..good luck

= = = = = = = = End of document = = = = = = = =