This is continuation of project as part 2 for card holder.
Adding a new part RFID casing to card holder. It is interesting to add a device which can minimize people from stealing your credit card with "wave" feature or skimmer trying to obtain illegally data on your card.
Let wait for his feedback.
Good luck and will update more idea for improvement.
On the look out for this improvement in next edition.. stay tune π
* one new idea came to mind was to have the money clip shielded from RFID casing by having a flap on it.
This is to minimize the money clip metal part bruising RFID casing.π
As when folding card holder,it will be better if there is an additional flap extend over the RFID casing.
Once this improvement is done will share out, so please keep reading π this blog and stay tune.π
Happy leather craft π΄End of document.
Adding a new part RFID casing to card holder. It is interesting to add a device which can minimize people from stealing your credit card with "wave" feature or skimmer trying to obtain illegally data on your card.
 |
| Discard unwanted cover on one side this to enable one side to attached on card holder. |
 |
| Make comparison to card holder and check size to RFID casing |
 |
| Remove unwanted black double sided tape from RFID casing |
 |
| Make preliminary measurement |
 |
| Add a money clip |
 |
| check on position money clip |
 |
| Remove unwanted panel from RFID casing .This will allow apply glue on surface |
 |
| Making adjustment for money clip, prepare where to punch hole |
 |
| Pre punch hole for inner layer |
 |
| Use rule to mark line. |
 |
| Add caption |
 |
| Add VT5 button, cut off part of inner layer for space VT5 button |
 |
| Punch hole for the outer layer and inner layer |
 |
| view with card deploy position |
 |
| Testing card holder with credit card and money |
 |
| Friend ☺ trail run on using this new card holder project. |
Good luck and will update more idea for improvement.
On the look out for this improvement in next edition.. stay tune π
* one new idea came to mind was to have the money clip shielded from RFID casing by having a flap on it.
This is to minimize the money clip metal part bruising RFID casing.π
As when folding card holder,it will be better if there is an additional flap extend over the RFID casing.
Once this improvement is done will share out, so please keep reading π this blog and stay tune.π
Happy leather craft π΄End of document.
No comments:
Post a Comment