Project coin purse /credit card holder
This is a request by relative for a simple coin purse with pocket for notes and credit card.
The original length is 12 cm and height is 12 cm.
Another version require length with 16cm cut and same height 12 cm.
Update on project . . . 🙆
✋ Work in progress and stay in tune for more update.
Update 31st Dec 2018.
✋ 1) Fair evaluation by user, gives some positive comment, this coin purse is bigger and a bit too bulky for Asian pocket.
2) It will be better if a bigger flap over lap the edge, easier to open close rather than use tag in this case.
👴 End of document
This is a request by relative for a simple coin purse with pocket for notes and credit card.
 |
| Make measurement use this coin purse / credit card holder |
 |
| Use heavy item to flatten material |
 |
| Slightly different version (16 cm length). |
The original length is 12 cm and height is 12 cm.
Another version require length with 16cm cut and same height 12 cm.
Update on project . . . 🙆
 |
| Layout material for project, check dimension base on photo |
 |
| Scratch surface before apply glue |
 |
| Layout cut material to match with outer layer. |
 |
| Cut curve edge |
 |
| Punch hole tool |
 |
| Punch hole for one side of inner edge |
 |
| Check position |
✋ Work in progress and stay in tune for more update.
 |
| Punch hole ready for stitchiing |
 |
| Cut hole to accommodate button head |
 |
| Hidden button head on tab |
 |
| end product of project |
✋ 1) Fair evaluation by user, gives some positive comment, this coin purse is bigger and a bit too bulky for Asian pocket.
2) It will be better if a bigger flap over lap the edge, easier to open close rather than use tag in this case.
👴 End of document
No comments:
Post a Comment