Card Holder #3 Part 1

          Card holder #3 part 1

       
Refer see previous project title "Trying make small gift", dated 17th July 2017.. 👀 

          Card holder with slight design for the flap and different material used.

Outer layer is cow belly and inner layer goat leather.
Button size use is VT5 and wax thread is 1 mm size.
Use punch hole of size 4.5mm.

Cow belly leather material

materials for card holder

cut drain line for punch hole

Finish product

Inside view

Rear view , the curve was due to stitching and
pulling too hard on thread.

Burnishing edge

burnishing edge

Learning point, it is important not to pull too hard during stitching as the leather is thinner and soft material.
That why the card holder is curved as it due to too tight pulling thread during stitching process.

End of document --  👲