Laser engraving image challenges (test phase) - レーザー刻印画像の課題（テスト段階）

 Have friend would like to try out engaving image of thier "SNOPPY" on their phone casing (Not sure of the material setting and fine tuning required some skill, expereince/ techniques) 

comparing display against actual output..the outline is not the same. Need to understand the cuase for mismatch.

Encounter the engraving image does not produce the expected result. Hence edit the iamge using GMIP sotware and retry engraving.

Encounter a plastic base decal label and difficities to engrave logo,

Sample of result test:-Engraving material plastic label

Tuesday, September 15⋅12:53 – 1:24pm

Plastic label ( offset up toward right ) Power set to 6 and speed to 6.000 ** too faint Now power = 20 speed same too faint Now power = 50 speed same too faint Now power = 50 and speed to 2 too faint Now power! 100 and speed to 2 too faint Select PLASTIC, copper plated cct bd. Power =30, speed = 6.000- OK but still faint

Still use own experience ,skill, past material and trail run on paper stage. After using the paper material and if it produce acceptable result then can proceed to the actual material, keep finger cross

Have another "Snoppy" image to test as the previous image the outline is not clear at certain location ( even after editing the line)

And thank you so much for your time and interest!

そして、お時間をいただき、関心をお寄せいただき、誠にありがとうございます!

- - - =  = - - - - =  =   =  = - - - =  = - - - - =  =   =  = - - - =  = - - - - =  =

* Note: This is trail use of "Google Translate" application from ENGLISH to JAPANESE, sorry if this translation do not make sense or suitable word or sentence, please do let me know and thank you.

* 注: これは英語から日本語への「Google 翻訳」アプリケーションの試用です。この翻訳が意味をなさない、または適切な単語や文でない場合は、申し訳ありませんが、お知らせください。ありがとうございます。

* 注：这是使用“谷歌翻译”应用程序从英语翻译成日语的尝试，如果翻译不通顺或有不恰当的词语或句子，敬请谅解，并请告知，谢谢。

                                          👦    End of  document   👴