Tobacco cigar holder 02

 Another design for Tobacco cigar stand / holder 02.

This design have four sided face to hold cigar.

Cut four piece of same size for this project.

size of project is 7 cm by 5 cm , qty four pieces.

Cut an arc on all four side layer. Use a plastic template to cut arc shape profile.

Tools use for cutting arch on four pieces.

Skive both side edge where the edge meet.

Tools and material used. Not inclusive of thread and needles.

Note: bottom right is a small container with wax, used when punching holes with prickling iron. 

Dip tips of prickling iron into wax container before use. This is to make it easier to remove prickling iron. 

Close up view where all four side are glued together.

Prepare to punch hole before stitching.

Top view

Different angle view on project

Coat all top edge with dye.

Tool and material for apply dye to edge.

Note:- dye used for fabric material type.

Apply dye on edge of project with awl tips.

Project completed..  Any comment or suggestion is welcome.

Update 16th March 2022.

Use a black marker pen to paint bottom edge of project.

Recommend to use burnishing tool on edge after black paint is dry.

Before apply black paint marker, it only apply brown dye at bottom edge.

                    👷  End of document 👴