Mini Tag RFID pouch

 

This project is for a Mini Tag RFID pouch. The device is for access to barrier gate to enter an apartment/ condominium home .

To make a pouch to hold the Mini tag RFID device which is attached to a key chain.

This how the project looks like, using a snap on hook.

 View of MAG CCD100 mini tag RFID. Verify where the sensor location.

Check overall size and measurement and thickness is about 8 mm, width 4.5 cm and length is 5.9 cm (sorry typo error on picture).

Use circle temple to draw line before cutting, the purpose of the hole is to allow the sensor path is not block off.

Add a stiff layer to hold the button post, as the project material is too soft to support. The other purpose is to conceal the button and minimize impact to Mini tag surface.

This step is important to check how long the strap needed and hook to a snap on clip.

It essential to ensure the sensor view is not block when the key chain is folded up.

Hence see the position for snap on and position of project.

To minimize pulling stress where the snap on "ring loop" with a strap over it.

Just add a small interface material to underneath strap.

Project completed.

Overall view and show how the key chain is used with new Mini tag pouch.

Note:- sharing inform on this device on how to remove casing to replace battery.

Please view this url link. https://www.youtube.com/watch?v=eZ9HeB9nRp8

title - How to change battery for CCD100? by MAG Security System  ( 0.38 minutes)

                              👷  End of document 👴