This is a slightly difficulty project base on my experience. The kitchen counter top below does not have cabinet, so decided to attached a frame to hold sliding netting door.
*Sorry if I did not use the correct terminology for this project as still learning.
Use super strength epoxy glue to attached aluminum tube frame 2" x 1" to the cement floor so to create cabinet.
The same goes for epoxy apply to five "L" bracket mounted on the wall to support the aluminum tube frame.
Use tape to temporary hold the upper frame part. Insert plastic film
Prepare to apply epoxy glue on top of "L" shape bracket to attach aluminum frame so that the frame are "solid"
Check all bracket before to ensure it is ready to hold the 2" x 1 " aluminium frame for lower part.
The lower frame with both end cover to prevent insect entering, hence in our case we use scrap leather and epoxy to seal the gap.
Temporary use tape to hold the frame to allow the glue to harden and set.
Tools used for this project
To be continue as it take time to allow epoxy to set and harden... stay tune.👀
👴 End of document
*Sorry if I did not use the correct terminology for this project as still learning.
The same goes for epoxy apply to five "L" bracket mounted on the wall to support the aluminum tube frame.
Use tape to temporary hold the upper frame part. Insert plastic film
Prepare to apply epoxy glue on top of "L" shape bracket to attach aluminum frame so that the frame are "solid"
Check all bracket before to ensure it is ready to hold the 2" x 1 " aluminium frame for lower part.
Temporary use tape to hold the frame to allow the glue to harden and set.
Tools used for this projectTo be continue as it take time to allow epoxy to set and harden... stay tune.👀
👴 End of document
No comments:
Post a Comment