Non Leather Project # 9 (Trolley Handle Wrap)

 Non Leather Project # 9 (Trolley Handle Wrap)

A friend fold able trolley was available to try out a project using leather of 2.0 mm thickness to wrap around the handle. Prefer a rough surface for better grip surface , user friendlier design and ergonomically.

In this case try out two separate wrap around on same handle of trolley. Since most of the time our hand grip a certain part of the handle hence decided to have two separate wrap material.

Overall view of this project before and after.

Cut a leather of size 15 cm (width) and 8.8 cm (depend on diameter of handle). 

One quick way to verify and check is use a scrap leather to confirm length to cut. Wrap leather piece around handle and mark position.

On this example the handle diameter is 2.5 cm and circumference is about 8.8 cm.

Stitch path length is about 15 cm, cut a thread length of about 126 cm (take into consideration of length for cross stitching). Remaining length of about 20 cm on both needle which just right left over. 

Details on how to terminate thread for cross stitch.

                                               👷  End of document  👴