Leather project #6 Part 2 (Order a Mould for emboss LOGO)

Leather project #6  Part 2 (Order a Mould for emboss LOGO).

Finally my design for logo have been accepted by supplier and receive item today.


Testing the different leather materials. Recommend to wet form the leather and keep press for extend period.





Try out this new machine with leather and non leather materials.









Testing on non leather materials


Found certain leather material is suitable for embossing pattern.
It work best where the leather is soak in water (wet form method)  and allow at least for about 1 to 2 hours to press the emboss device.
Obverse certain leather have limited capability to retain it shape. Hence need to verify








                    End of document 

No comments:

Repair drill chuck key holder

 This was relook as the original method was a leather strap is tie to a key ring and latch to key. Over time the leather broke off. Now I ha...