Encounter recently where water tank over flow due to maladjusted float and float ball was tilted one sided due tank distorted in shape. This resulted floated is ineffective and malfunction..this possible root cause.
So cut a new non metal washer for better support to tank wall to tighten float mechanism.
Cut a new hard plastic to provide better support for the push rod for the diaphragm.
👴
Position the new plastic diaphragm at correct position
Short push rod hole is visible and that where the diagram sit.
Re insert push rod
Add new plastic washer for the float mechanism.
Prepare to install float mechanism to water tank
End of document 👴👴
So cut a new non metal washer for better support to tank wall to tighten float mechanism.
Cut a new hard plastic to provide better support for the push rod for the diaphragm.
👴
Short push rod hole is visible and that where the diagram sit.
Re insert push rod
Add new plastic washer for the float mechanism.
Prepare to install float mechanism to water tank
End of document 👴👴
No comments:
Post a Comment