Non-Leather Project

 Workshop table to have better support for CLAMPing device on work bench. As sometime the clamp need a deeper and wider support surafce underneath worbench, the default clamping aera is very small foot print ( the original foor print is very limited surface area).

the two G clamp to hold a vice to work bench surface. At time it need a deep /wider support surface for clamp foot to grip. As the workbench design is just a angle surface with limited surface area.

To add the greater surface area underneath is to add a wooden block that fit into the angle bench,

Hence use a wooden block that fit within the space.

This what the wooden looks likes.

Cut three wooden block and "chain" with a strap so that it can configure underneath the work bench use,

Cut three wooden block and "chain" with a strap so that it can configure underneath the work bench use,

View on how to attached three wooden block underneat the work bench

the block have one edge chamber at an angle to allow ease to underneath insert

How to add a strap to ensure wooden ease to move about underneath the work bench

And thank you so much for your time and interest!

そして、お時間をいただき、関心をお寄せいただき、誠にありがとうございます!

=* =* = *=* =* = * =* =* = *=* =* = * =* =* = *=* =* = * =* =* = *=* =* = *

=  = - - - =  = - - - - =  =   =  = - - - =  = - - - - =  =   =  = - - - =  = - - - - =  =

* Note: This is trail use of "Google Translateprats" application from ENGLISH to JAPANESE, sorry if this translation do not make sense or suitable word or sentence, please do let me know and thank you.

* 注: これは英語から日本語への「Google 翻訳」アプリケーションの試用です。この翻訳意s味をなさない、または適切な単語や文でない場合は、申し訳ありませんが、お知らせください。ありがとうございます。

                                          👤     End of  document   👨